SentrySafe SFW123FSC Owner's Manual download pdf (Page 4)

6 7

English

NOTE:•Store code (and keys if equipped) in a secure location

(other than in the safe).

Ensure any shipping screws have been removed. Located on

the inside of the door.

NOTE: Your unit may or may not have a shipping screw.

•DO NOT RETURN! Questions or concerns, call us at

1-800-828-1438.

Slide out the battery drawer on the side of the keypad.

Insert 4 AAA alkaline batteries (not included).

NOTE: Do not use rechargeable batteries or any other type

of non-alkaline battery. Do not mix old and new

batteries. Do not mix alkaline and standard batteries.

Slide battery drawer back into keypad.

Find your code on the back of this owner’s manual.

FOR DUAL KEY/COMBINATION LOCKS ONLY

Keys are located inside your safe. Be sure to remove them

before locking your safe.

WARNING

Test your code several times before putting valuables inside.

FOR DUAL KEY/ELECTRONIC LOCKS ONLY, insert key into

the lock, turn to the ’unlocked’ position to open the safe, then

remove the key.

This is a secondary locking feature not an override key.

The key lock needs to be in the unlocked vertical position

before entering your code..

Programmable Electronic Lock

Preparing your safe for ﬁrst time use

Unlocking your safe

M100TEST

SN100TEST01*

12345

Enter the 5 digit factory code found on the back of the

owner’s manual.

NOTE: You may have to lift the handle while entering the

combination.

A green light will indicate the code is correct. You will have

4 seconds to turn the handle to unlock your safe.

Rotate the handle downward to open the door.

This may take a limited amount of force if you have a water-

resistant safe.

NOTE: •Make sure the handle is rotated all the way up in the horizontal position before

unlocking the safe.

 •If you exert too much force on the handle, the handle will move without moving the

bolts. If not when this happens, you will hear a ’click.’ DO NOT be alarmed. This feature

is designed to protect the bolts from being over powered by force. If this occurs, simply

exert force in the opposite direction (lifting up) until the handles ’clicks’ back into place

and repeat steps 1-3 to open your safe.

 •Delay mode will occur if three consecutive invalid entries have been tried. Red LED will

blink on and off to let you know the safe is in delay mode. This will cause the system

to shutdown for two minutes. DO NOT remove the batteries to restart the system it will

only increase the length of time for the system shutdown.

Close the door and pull the handle upward until the handle is

horizontal.

For water-resistant units, additional pressure to the front,

left side of the door may need to be applied prior to rotating

the handle.

FOR DUAL KEY/ELECTRONIC LOCKS ONLY, insert key into

the lock, turn to the ’locked’ position, then remove the key.

NOTE: If your safe does not appear to be working properly,

please check to make sure you are using NEW

alkaline batteries before contacting SentrySafe

Customer Service.

Locking your safe

1 2 3 4 5 6 7 8 9 ... 23 24

Comments to this Manuals

No comments

SentrySafe SFW123FSC Owner's Manual Page 4

Comments to this Manuals

Related products and manuals for Safes SentrySafe SFW123FSC