SentrySafe SFW205TWC Instruction Manual download pdf (Page 4)

THE PROBLEM: WHY IT IS HAPPENING: THE SOLUTION:

The door will not lock. 1. Shipping screw is in place.

2. Conﬁrm that there is no obstruction in the door.

1. Remove the screw on the back inside of the door.

2. Remove all items and accessories from inside the safe.

If this resolves the issue, re-set the accessories and organize items to properly ﬁt.

The handle is not in the horizontal

position when the safe is locked.

The clutch mechanism has been engaged. Rotate the handle up or down until it clicks into the horizontal position.

Cannot open door after inputting the

electronic code.

1. Safe doors equipped with a water-resistant gasket may initially be tight.

2. Key lock is in the locked position (select models only).

3. Battery power is low.

1. Hold the handle up while inputting the code and then pull down on the handle.

2. If your safe is equipped with a key lock ensure that the key is in the unlocked position

(select models only).

3. Use auxiliary battery connection to gain access to your safe and replace main batteries.

Red indicator light blinks three times

and there are three beeps.

An incorrect code has been entered. Verify code and re-enter. If the programmable code you are using doesn’t work then use

the factory code. If successful re-program your programmable code.

Red indicator light blinks ﬁve times

and there are ﬁve beeps.

Keypad communication error. Please call our Customer Service center.

Red indicator light blinks once

and there is one beep.

Program button is pressed out of sequence. Start over.

Yellow “low battery” light is blinking. Battery power is low. Replace batteries.

Cannot open door after inputting code and

yellow “low battery” light is on.

Battery power is low. Lock may not function properly. Use auxiliary battery connection to gain access to your safe and replace main batteries.

Alarm is triggered. Safe has been moved, jarred or an incorrect code has been entered 5 times. Wake up the safe and enter a programmed code or factory code.

Red alarm and red error light are blinking. Alarm was triggered. Wake up the safe and enter a programmed code or factory code.

Alarm frequently goes off. Alarm programmed too sensitive. Change sensitivity by following directions under “Audible Alarm Features” in this

owner’s manual.

Troubleshooting

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

SentrySafe SFW205TWC Instruction Manual Page 4

Comments to this Manuals